Aircraft Spruce Australia
Melbourne, VIC Australia
Aircraft Spruce Australia- Wishlists
- +61 (1800) 953522
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Bowden Cable Inner Wire
MFR Model# SSW-078
- JUMP TO
- Overview
- Accessories
- Reviews
- Q&A
- View in Catalog
Overview
| Stainless stainless steel wire .078" diameter. Sold by the foot. |
Reviews
Good quality product.
Verified Purchase
Bowden Cable Inner Wire
Nice stainless wire for my combine header control. Quick shipping allowing a quick repair and back to harvest
Verified Purchase
Bowden Cable Inner Wire
The wire is too thick for Piper 32 alternate air contols. Does not fit into the cable hose.
Verified Purchase
Bowden Cable Inner Wire
The product is exactly as described. Unfortunately, the diameter of cable inner wire needed for the M20E flap control cable is smaller (0.053 in.) than 0.078 in.
I bought this part to replace the cable on an ACS A-800 throttle, that was cut too short. Apparently, the ACS A-800 has a special connection at the knob-end, so this part didnt work. Tried to reach Technical Service three times and left 3 messages, but didnt get a call back. The part was fine, but wasnt useful to me.
Did not use. Wire too heavy for trim tab application.
Q&A
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
It is .078" solid wire.
Yes, it is priced and sold by the foot. For 14 feet, enter qty 14.
No it can not, at least not with our tooling. We swage these units to cable not solid wire.
