EGT Probe, Type K, Style 86255 P/N 11-01022 CHT Probe, Type J, Style AN5541-1 P/N AN5541-1 CHT Probe, Type K P/N 11-01023 Cessna CHT Probe P/N 06-00703 Note: These probes will only work with a grounded system.
|
As advertised. Exact replacement. Works great! The fiberglass wire heat shield could have a bit longer.
EGT Probe Type K, Mm-111
Good quality, fast acting probe that is FAA-PMA approved.
EGT Probe Type K, Mm-111
Corrected indication issue
EGT Probe Type K, Mm-111
Perfect replacement
EGT Probe Type K, Mm-111
Great product. the order was processed quickly
EGT Probe Type K, Mm-111
Good but to short for my Project and i must return
CHT Probe, Type K
Probe fit as a direct replacement and was easier to install in a P32T. The red and yellow leads would be better with opposing lengths, but just folded the red and covered with existing sleeve. Probe is more sensitive, which allowed a more accurate setting during run up.
EGT Probe Type K, Mm-111
This thing is longer and bigger around than the one I was replacing. Large fins surrounding it so it gets in the way of adjacent plug wires easily. It’s not your normal skinny EGT probe.
EGT Probe Type K, Mm-111
Over priced Cessna part! Not Spruces fault. This is why no one can afford to fly anymore!
Cessna CHT Probe S2334-3
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, the AN5541-1 will fit into the 10-00374 CHT adapter.
Yes, the Insight Gem uses a type K grounded probe.
The clamp included is 1.56"-2.5". A 3.5" clamp can be ordered separately.
The wires are about 1ft long. To extend the leads, you will need type k thermocouple wire.