A mixture of plasticizers and solvents which soften butyrate dope finishes. Available in quart, gallon, and 5 gallon sized. |
Randolph J-3000 Butysolv Rejuvenator Gallon
Butysolve reminded me of why Randolph dope finishes are still in use 100+ years later. The PA-12 was recovered 25 years ago, and I recently noticed hairline cracks in the dope where it passed over an underlying hardpoint. Start by a thorough cleaning - think air show. You want to look at every square inch of the finish and identify every crack, as opposed to old bug strikes. For a small hairline crack, apply straight Butysolve and rub the existing dope with your gloved finger. That will fill the crack and restore flexibility to the finish. If you can see the bare fabric, you need to add silver, then top coat. Ill try to attach photos that show the result of Butysolve alone, and then a larger crack where I brushed silver then wet sanded to prep for the two color coats. Following is the Randolph product description: Rejuvenator adds fresh plasticizers to old, brittle dope coatings. It restores flexibility and suppleness in dope finishes that are cracking, ring worming, or losing adhesion. It softens and slightly flows old coatings to allow hairline cracks to close and fill. It does not restore color or gloss to faded Colored Dope, nor does it fill big cracks or voids. NOTE: Rejuvenator only works if Colored Butyrate Dope is used as the topcoat it will not penetrate polyurethane paint of any type.
Received without damage.
Response was rapid, salesperson was nice to deal with.
the can was baddly dammage but not leaking
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes, this can be applied in small areas.
No colder than 60 degrees.
The vendor instructions recommend spraying only. It would probably be ok to brush but it would be at your own risk.
Typically it is used for the butyrate finishes in color and in silver. If the coating system is it not in that state, it should be coated up through silver before butyrate rejuvenator should be used. Usually one has patch area to be built up from nitrate before one rejuvenates the the repair and surrounding area.