Pilot Size | Decimal Equiv. (in.) | Body Dia. (in.) | Part No. |
---|---|---|---|
#30 (1/8" rivet) | .1285 | 3/8 | 12-00880 |
• Made in the U.S.A. • High Speed Steel • 1/4" -28 Threaded Shanks • 100° 3-Flute Precision Ground • For Use in Micro-Stop Countersink Units |
Great Quilty
Avery #30 X 3/8 Csnk Cutter
Avery #30 X 3/8 Csnk Cutter
Does a great job! Im very happy
Avery #30 X 3/8 Csnk Cutter
Avery #30 X 3/8 Csnk Cutter
I ordered for will call but was told it was not in stock and would have to be mailed from california for the cost of postage which I agreed too. This is a small one inch long x 3/8 dia item which should have been less than $3 to ship. instead I will billed over $6 which was abougt half the cost of the bit. Seems there is a minimum that I was not told about so disappointing.
Avery #30 X 3/8 Csnk Cutter
As expected
Avery #30 X 3/8 Csnk Cutter
cant wait to use them!!
Avery #30 X 3/8 Csnk Cutter
Avery #30 X 3/8 Csnk Cutter
Good product, prompt shipping.
Avery #30 X 3/8 Csnk Cutter
Avery #30 X 3/8 Csnk Cutter
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the supplier: Yes, 12-00879 would be the correct size cutter for 3/8" and 1/2".
Per the supplier: yes, it can work on 4130 steel, but it will wear out the cutter a bit more than what it is designed for (aluminum). We also suggest to use some type of lubricant for the 4130.
These are designed for aluminum. They might work with lexan but we recommend trying it on scrap first to may sure.