Aircraft Spruce Australia
Melbourne, VIC Australia
Aircraft Spruce Australia- Wishlists
- +61 (1800) 953522
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Loos & Co Locoloc Go-No Go Sleeve Gauge
MFR Model# GA-1P
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
|
To assure proper swaging of Locoloc® aluminum, copper and stainless steel sleeves with Locoloc® tools these simple, “Go” “No-Go” Gauges will determine if your tools are out of adjustment or alignment. When the proper slot in the gauge slips over the compressed area of the sleeve after swaging then your swage is satisfactory. If the proper slot does not fit over the compressed area of the sleeve after swaging, then your tool is out of adjustment. Your cable assembly will not hold the rated breaking strength of the cable, which should be the result when oval sleeves are used to form a loop or eye in a cable assembly. Stop sleeves must also be properly compressed and gauged to reach their rated loads which is 1/32 to 5/16 the breaking strength of the cable, depending on cable diameter. The Locoloc® sleeve gauges will measure all oval or stop sleeves used on 1/32″ up to and including 5/16″ diameter cable. GA-1P – Gauges 1/32″, 3/64″, 1/16″, 3/32″, 1/8″, 5/32″, and 3/16″ oval and stop sleeves. |
Reviews
works as advertised
Verified Purchase
Ga-1P Go No-Go Sleeve Gauge
Exactly as described. Will do the job perfectly.
Verified Purchase
Ga-1P Go No-Go Sleeve Gauge
Checking your own work is so important. This is the tool.
Verified Purchase
Ga-1P Go No-Go Sleeve Gauge
Very close tolerance an excellent go/no go gauge
Verified Purchase
Ga-1P Go No-Go Sleeve Gauge
Works well
New products very satisfying with.
New products very satisfying with.
Would give 5 stars except the labeling on the gauge is paper, not engraved as others are. In order for the labels to remain legible I have to cover them with packing tape. Otherwise the oils and grease turn them black
Used a paper label for the markings. that will soon wear off and you wont know which is which.
Q&A
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the supplier: No certs are available for this gauge.
Yes, this does nicopress sleeve sizes, 1/32, 3/64, 1/16, 3/32, 1/8, 5/32, 3/16
Part # 13-03814 is the correct gauge, it will work with the nicopress sleeves.
