NOT FAA APPROVED. INTENDED FOR USE ON EXPERIMENTAL AIRCRAFT ONLY.This easy-to-install tail skid is designed to save the tail cone on most single engine aircraft. Just remove the existing tail tie down ring and reinstall both on aircraft. 6-1/4"L. Stainless steel. |
Works great!
Aircraft Tail Skid - Non FAA-PMA
it left a skid mark.. not on the runway
Aircraft Tail Skid - Non FAA-PMA
Aircraft Tail Skid - Non FAA-PMA
Easy to install, does the job of protecting tie down ring.
Looks like the perfect solution to protect that tie down ring. A good value for the cost.
We install these on all of our customers airplanes. Our Cessna 150 has one. Well worth not tearing your tie down ring off and causing bulkhead damage.
Installed this on a Cardinal as my son is using the plane for flight training. The tie down ring bolt was too short to re-install, so I used a straight bolt and a few washers to install it. Fits great and will prevent a tail strike as the spring steel hits the ground prior to the tailcone.
Just what I needed for my planes. Tired of seeing the tiedown ring worn away because instructors want students to keep the nose up. Kinda tight, but a bit of rolling works great.
Nicely made, hole was too big for my eyelet, needed a washer and the radius was too small to fit around the eyelet. Bent it the way it needed to be and put a washer on it and works good.
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The weight is approximately 0.43 lbs.
Yes, that is correct. It is roughly 1" x 6", thickness 3/16.
Per the manufacturer: This is not FAA approved and there is no paperwork included.
This item is not FAA approved for certified aircraft, it would require a 337 to install it on your aircraft.