WIRE GRIP - Is a unique fitting which securely attaches to solid wire end push-pull cables. Uses a "pin vice" gripping action to attach a cable. The 5/8" long 10-32 threaded end will attach a clevis, ball joint, or other hardware for use with mixture controls, carb heat box, cabin air, or other applications, resulting in a clean, professional installation. Note: Use PN 05-16001 on A790 ACS controls. Made in USA |
I dont normally give reviews, but this device is amazing!!
Wire Grip 10-32 Control End Blue
Wire Grip 10-32 Control End Blue
Excellent quality
Wire Grip 10-32 Control End Blue
Wire Grip For .078 Dia-Red
I never saw one of these until I was replacing my throttle cable. At first, I was skeptical to the holding strength... they are precision made, the bowden cable fits snug before tightening.. grips hard.....make sure all parts are clean before assembling..
Wire Grip For .078 Dia-Red
Overpriced
Wire Grip Shaft + Cap .040 To .050 Od
Im loving this product so far. My only concern is longevity and dependability. If I designed this I would have added a lock-nut behind the wire-catch.
Wire Grip For .078 Dia-Red
love it
Wire Grip For .078 Dia-Red
Needed to connect a wire pull cable to a clevis ..this device is the ideal solution ...works great
Wire Grip Shaft + Cap .040 To .050 Od
Clever solution for connecting Bowden cable to threaded terminal. Well made. I pull tested after assembling wire grip to cable and it withstood a 100 pound pull with no sign of slippage.
Wire Grip For .078 Dia-Red
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
You can select one of the two sizes available. Either .050" thru .060" or the .078" unit.
This wire grip is 303 stainless steel.
The length is 1-7/8".
No. This was designed for solid wire applications only.
The wire grip portion is not threaded but the threaded end is 10-32 (3/16).
This works with A730, A1770, A740, A1780 cables.
There are fingers inside the sleeve that compress as you tighten it down. Its basically a pin vice.