Aircraft Spruce Australia
Melbourne, VIC Australia
Aircraft Spruce Australia- Wishlists
- +61 (1800) 953522
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Appareo Interface Kit 153010-000017
MFR Model# 153010-000017
Overview
| Pilots can enjoy a no-compromise ADS-B In experience on the iPad by connecting a Stratus portable receiver through this interface kit. This connection provides continuous power to Stratus portables as well as access to the ADS-B and GPS antennas mounted in optimal locations outside of the aircraft. Thus, it eliminates the need to mount Stratus portable receivers in direct line of sight of ADS-B ground stations and GPS satellites. |
In The Box
- Stratus connector plate
- 9 Pin DSUB connector with strain relief
- BNC connector
- BNC jack to blind mate adapter
- Power/serial interface cable
- RF interface cable
Reviews
Bought several of these for install, as well as the 3i Kit. Love the product, and I have yet to have any problems with missing or defective parts. Great solution for low cost ADS-B in/out when paired with the ESG Transponder.
After reading the review complaining about a lack of cables I ignored it, thinking it must be a one-off - bad assumption. I too received a kit absent any cables. The Appareo guys initially said theyd never heard of such a thing, one assumes they thought I was trying to rip them off, but they have now shipped the cables. I fear this may still go wrong, Aircraft Spruce simply sent a form response with platitudes, though they did engage with the supplier, so I guess that probably persuaded someone. In hindsight I should have simply sent the partial kit back and asked them to supply a properly kitted set. Ill update this review if everything works out.
We received the kit with missing and defective parts. Aircraft Spruce referred us to Appareo. First they sent the missing parts, and when installed, we found that one of the original parts included in the kit was defective and we had to again go through Appareo to get the replacement part. It cost us additional installation expenses as well as additional down time for the aircraft.
Q&A
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The cables are 5' long.
No, it only allows the Stratus 2S & the Stratus 1S to be remote mounted.
Please see part #'s 11-15996 and 11-14672 for the respective compatible antennas.
Yes, this can be used in certified aircraft.
Yes, you will need the interface kit.
The 3 is the newest one. There is no S version of the 3 at this time. Part # 11-16213 will only work with the Stratus 2. Part # 11-14673 is made for 1s,2s, and 3
No, this is only for the stratus portable units in order to interface them to their respective transponder.
These come together as a kit from Appareo and cannot be separated. However we can look into special ordering this from the manufacturer.
Correct, this will only work with the Stratus.
