Aircraft Spruce Australia
Melbourne, VIC Australia
Aircraft Spruce Australia- Wishlists
- +61 (1800) 953522
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Avery Vise Grip Dimpler 3/32
MFR Model# 550
- JUMP TO
- Overview
- Reviews
- Q&A
- View in Catalog
Overview
| Made for dimpling in restricted and hard to reach places where regular dimple dies won’t fit. Made with 7” VISE GRIP plier. Machined tool steel dimple dies are T.I.G. welded to the VISE GRIP jaws then polished. 2 sizes available (3/32” and 1/8”). |
Reviews
These will dimple in tight spaces
Verified Purchase
Avery Vise Grip Dimpler 3/32
Expensive but just the right tool when needed. Keep the spacer in the jaws.
Verified Purchase
Avery Vise Grip Dimpler 3/32
Works great for small areas
Verified Purchase
Avery Vise Grip Dimpler 3/32
These vice grip dimples are a must have for any aircraft builder
Verified Purchase
Avery Vise Grip Dimpler 3/32
Verified Purchase
Avery Vise Grip Dimpler 3/32
Arrived in two days UPS ground and in excellent condition. Worked as stated.
Good quality tool and works well for medium-small spaces. Isn’t quite the whole solution for a very tight space. I had to bend out the end of a rib to fit the tool in.
Q&A
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes that is correct.
The dies are welded onto the Vise Grip jaws with about 1/2 of the die diameter extending out past the jaws. Measuring from the center of the dimple die you have about 1-1/8 to the back of the jaws. That should give you 1 to 1-1/8 reach from the edge of the material to the center of your hole to be dimpled.
This is 100 degree.
