Mounts in standard 2-1/4" instrument hole. Standard equipment in most production aircraft. Operate on any DC voltage from 12 to 24 volts. These solid-state hour meters are recommended for use on aircraft because they start or stop instantly when power is applied or removed. Furnished with mounting hardware. If meter is connected improperly it will not operate but meter will not be damaged. The running indicator indexes every 6 seconds. |
Worked well. Have had it now for about 3 hours of flying. So far so good.
Datcon Hour Meter Mdl # 873
got it, installed it and it works... thanks
Datcon Hour Meter Mdl # 873
Worked great
Datcon Hour Meter Mdl # 873
Datcon Hour Meter Mdl # 873
This Hobbs was delivered ahead of schedule and in perfect condition. Works great!
Datcon Hour Meter Mdl # 873
Datcon Hour Meter Mdl # 873
Arrived on time and works great so far!
Datcon Hour Meter Mdl # 873
I installed it and it worked.
Datcon Hour Meter Mdl # 873
Just installed the third one in as many months. they stop intermittently until a knock on the panel next to it starts it up again. maybe a bad batch?
Datcon Hour Meter Mdl # 873
AS Expected
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Yes you can order with preset time (put is the special instructions box or tell sales rep at time of order). Lead time is about 6 weeks and can run around $75.00 (price subject to change).
There is no physical difference between the two units. The rear tabs are the same on the 773 and 873.
The Datcon 873 is 2.06" long. Total depth behind the panel is 1.43".
It draws 500mA for a 47 millisecond pulse every 6 seconds at 14vdc. A 2 amp fuse is recommended.
Only the manufacturer can reset the hour meter.
No, experimental use or direct replacement only.
Yes, the hours can be set for an additional charge. To set hours, order part # 10-06221 with the unit. Please note this makes the product special order so the lead time will be delayed.
No, it does not require an oil pressure switch to operate.
This is intended for use in experimental aircraft only.
This hour meter weighs approx 0.183 lbs.