Eaton Aeroquip Sleeves. |
Met our requirement
Eaton AE102-11 Firesleeve
Just what I needed
Great product!
Great service as usual
High quality & finishing.
This item fits and works great. The inside is soft and will flex when the hose sides into the fire sleeve. I just cut with scissors the full length of hose with fittings on and this will cover any bends of your hose. If sleeve is to long just push back and the slack will go back down the hose and still look great. One thing I found when installing the sleeve on a long hose was to use a long air blow tube from the air compressor line and insert it down the hose between the fire sleeve and the hose that the fittings are already on. I found that the blow tube should be on the end of the sleeve in the direction of travel. Blow air and just side the sleeve up the hose with now problem. I also used plugs at both ends to keep contamination out of the hose
Too expensive
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
These Aeroquip fire sleeves are priced and sold by the foot.
Per the dims, AE102-8 fire sleeve would fit.