Aircraft Spruce Australia
Melbourne, VIC Australia
Aircraft Spruce Australia- Wishlists
- +61 (1800) 953522
- Contact Us
Contact Us
Call Us
Sign In
- Photo may represent series and not specific product
- SHARE
Lamar Continuous Duty Solenoid
12 Volt
24 VoltOverview
|
FAA-PMA APPROVED for Certified Aircraft Continuous Duty (Aux) Solenoid. Typically used for connecting Auxiliary (Ground) Power. Activation: Varies. |
Features
- Silver Contacts provide 300A in-rush & 150A continuous-duty capability. Much higher than the original units
- Light spring and low-current coil for excellent engagement and holding capability
- Dual coil terminals
Specifications
- High Quality Manufacturing designed to take the beating our piston aircraft dish out
- Upgraded to perform best with today's lightweight, high torque starters
- Not automotive store parts with extra mystery terminals
- Same OE terminal layout used for decades on our aircraft - simple to install
- Silver contacts (vs. copper) for high-current capability and long-life
- All-metal case construction
Reviews
Suitable for use where external power comes on board or as an avionics master. Not for use as a Batt-Master.
Verified Purchase
Sky-Tec Sts-A12 Continuous Duty Solenoid
Excellent!
Verified Purchase
Sky-Tec Sts-A12 Continuous Duty Solenoid
So far product is working great.
Verified Purchase
Sky-Tec Sts-A12 Continuous Duty Solenoid
Just what I needed and heavy duty item!
Verified Purchase
Sky-Tec Sts-A12 Continuous Duty Solenoid
So far it is good. It was previously replaced in 2016.
I need to purchase two 24volt battery master solenoids. There appears to be some confusion in the online catalogue between the STS-M24 and the STS-A24. Can you please advise the correct part number for the continuous duty 24 volt battery master solenoid. It is listed as part number 07-03566 (STS-A24 )in your catalogue as a continuous duty but the specification shows this number as being an intermittent duty solenoid.
Work great.....no issue
Good quality certified solenoids
Good quality with higher amp ratings then the ones usually found at other suppliers.
It seems to be a decent product but the paperwork needs improvement. The documentation references the terminals labeled Bat and S1 and S2 but nothing is labeled on the solenoid. It also does not indicate if there is a preferred mounting position or if a diode may be required.
Q&A
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
This weighs approximately 0.92 lbs.
The diode is not included per the vendor.
.46 x .28
Yes, 8130-3 can be furnished upon request at time of order, additional fees may apply.
