Nylo-Seal tube fittings are exceptionally strong. The bodies, made of nylon, are stronger than machined fittings of similar composition. They are furnished complete with nut/sleeve assemblies, made of acetal copolymer. Since the sleeve snaps into and is retained by the nut there is no fumbling for a loose sleeve. Just insert tube into the fitting and tighten the nut 2 to 2-1/2 full turns. Note: The most frequently used combination of tube and pipe sizes are 1/4" Tube x 1/8" Pipe and 3/8" Tube x1/4" Pipe.
For Nylo-Seal tubing, see "Accessories" tab Less 10% on 50 pieces per size, Less 20% on 100 pieces per size |
259-N Insert (Nylon) | Sleeve Assembly | |||||||||||||||||||||||
|
|
| |||||||||||||||||||
|
264-N Union Tee | ||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||
|
268-N Male Connector | ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||||||||||
|
| ||||||||||||||||||||||||||||
|
*Use 259N inserts w/all Poly-Flo tubing connections. Not needed w/ Nylo-Seal tubing. | |
exactly as advertised
Nylo-Seal Fittings 259-N 04
Perfect fit, problem solved.
Nylo-Seal Fittings 259-N 04
Would have worked fine, Just don’t lose the bag in the hangar! Thanks Central Florida Avionics for supplying us with a few!
Nylo-Seal Fittings 259-N 04
Nylo-Seal Fittings 259-N 04
Nylo-Seal Fittings 259-N 04
FYI. These are a must have on the end of tubing at every fitting.
Nylo-Seal Fittings 259-N 04
very helpfull
Poly-Flo Fitting 259-P 04
Nylo-Seal Fittings 259-N 04
Good part. Thx
Nylo-Seal Fittings 259-N 04
works good, lasts a long time!
Nylo-Seal Fittings 259-N 04
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The first number in the size column refers to the tube OD, second number is the pipe thread. In your example, 1/4 tube OD x 3/8 pipe thread.
You would install a cap in a fitting where you would want to cap off the flow. Place the cap in the fitting and tighten the nut down.