Safe, Affordable, Airframe Power for Piston and Light Turbine Aircraft |
Thank God you carry this product. My manufacturer maintenance docs require a power supply like this for landing gear calibration. Thank you!
28-Volt 70Amp Ground Power Unit (GPU)
Great GPU so far. I have used it a few times and the power is stable and works as advertised.
28-Volt 70Amp Ground Power Unit (GPU)
Absolutely an outstanding product. I had mine for 9 years with no problem . Truly a great product. I just bought my 2nd one.
28-Volt 70Amp Ground Power Unit (GPU)
High quality construction, very pleased with its use for ground testing and exercising of new avionics system, very well regulated output. The digital volt + ampere meter can be used quickly to make a load (amp. draw) shedding chart for all of the electrical loads which can be switched off in an emergency.
28-Volt 70Amp Ground Power Unit (GPU)
28-Volt 70Amp Ground Power Unit (GPU)
Your are specifically not authorized to use any comment or endorsement for our order. We are compensated for product endorsements. In the interest of providing internal feedback to you, your delivery time exceeded our expectations, product was packed very well. We are likely to continue to do business with you. next--I would like to find a very cost effective lightweight portable jump start for a 24 volt three prong Cessna 414. Lots of very expensive ones in your catelog. Im sure good quality. Just expensive
Very well made, quality product. Perfect for my 28V Bonanza.
Took a while to get since it was backordered but really works well on my Citation. I am on a little airport with no power carts and this saves my battery for engine starts big time
So far so good. I have used it a few times and the power is stable as advertised. The screws that hold the rubber feet on the bottom of the unit were all bent and one was even broken off. I managed to fix it myself and replaced all the screws. Otherwise the product is great.
28-Volt 70Amp Ground Power Unit (GPU)
When it says 70 amps - thats exactly what it means. There is no tolerance or time delay - it just switches off at 71 amps.
28-Volt 70Amp Ground Power Unit (GPU)
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
No, this is only 28v output.
The GPU itself may be used with almost any voltage, but the internal BatteryMINDer is only compatible with a 100-127V AC power source. In countries with other voltage standards, a compatible BatteryMINDer must be purchased and used separately.
No, this unit is intended for powering up avionics units without the engine running.
The AC cable would be 6-1/2 ft. long. This cable would come with the purchase. The 28VDC specs are 28 +/- 0.5 Volts DC, 35 Amps continuous.
This unit has Universal input: 100-240 VAC 50-60Hz 9.5A.
The 2870A GPU is compatible with all piston and turbine aircraft with 28 VDC electrical systems (24 volt batteries) that initially draw less than 70 amperes without optional equipment turned ON. This includes most piston aircraft and a large number of turboprops and small jets.
Per the manufacturer: No, the FAA is the sole governing authority on modifications of certified aircraft. The BM-AIK kits have been reviewed by FAA and industry personnel, who agree that its installation does not rise to the level of a major alteration to the aircraft. Only a major alteration, as defined by federal aviation regulations, requires an STC, or FSDO field approval, and filing an FAA form 337 to document the change. It is not the decision of the airframe manufacturer, or type certificate holder. Because it is NOT a major alteration, it is a MINOR alteration, which is within the authority of the installing mechanic to sign off with a simple maintenance log entry.
This would depend on the load of operations being performed. The more systems being used such as avionics or cabin environmental controls, the more draw. Each unit has built in active load monitoring to prevent overload.