Great for making P-leads! Use the outer braided shield for the ground: just remove a couple inches of outer casing from the ends, unbraid the shield, then twist it together and slide it into the removed outer casing. Hold it all together with a 1/2 long, double layer of heat shrink tube, centered over where you cut the outer casing. Crimp ring terminals on the ends and youre done. Dont forget the silicone nipples!

Gelston A Verified Purchase

Shielded 16GA White Wire M27500-16TG1T14

Excellent

Danny H Verified Purchase

Shielded 16GA White Wire M27500-16TG1T14

Product was correct came in on time worked out perfect for the job

Excellent, quick service. They sent me a very short amount of shielded circuit wire. It had been difficult to find someone on the Internet that would send me such a small amount.

I got it and it works

Good

good product/ great service. A+ thank you very much

Excellent service

Excellent online experience. this is the PERFECT wire for my application. This is a very high quality shielded wire, Very small overall diameter even in the larger AWG sizes... The 22 AWG I am using is perfect for my application.

Outstanding condition, great packaging, meets spec and shipped fast

Got just what I ordered delivery was fast . Have always gotten good service from our craft Brewers. Have been purchasing from them for many years for experimental and certified aircraft.They are always helpful when you have questions.

quick service and shipping

received very fast, product as expected

Super quality, Exactly as ordered.

Received in good condition as advertised. Happy with the product.

Product was just as describe. Aircraft Spruce is one of the few places where you can find a myriad selection of shielded wire in different gauges cut to length. Would definitely purchase from them again in the future.

Its Mil spec ... excellent quality!

Readily available stock, quick response and shipping. An excellent experience.

Good product, fast shipping. Used it to make a P-lead for my Fairbanks Morse magneto on my cut case 1/2vw engine.

Good quality product. I used on the intercom system as recommended per the manufacturer. Easy to strip, but you have to use the correct gauge stripper.

EASY ORDERING AND PRODUCT SHIPPED RIGHT AWAY.

Works great! Conducts electrons as advertised.

This appears to be MIL spec shielded wire. Probably wont go to jail for installing this.

As advertised. Could find no fault with this wire.

Perfect, excellent delivery time,

Perfect product for limiting RFI.

Once again Aircraft Spruce delivered a great product in a timely manner.

Slim cable, not overly bulky. Appears to be high quality. Im intending on using it as a signal carrier in Guitar tube amps. I feel it is superior to foil jacketed coaxial cable and much more flexible as well. Good prices, fast delivery and preparation by the sender. 5 Stars!

What it says on the box and delivered quickly (would have been 5 starts but, inevitable it seems nowadays, the delivery charges are still high) Thanks

It seems to meet the minimum specification and Im happy with the noise-free result of the install. But compared to other wires Ive used, the shielding has fewer strands at a thicker gauge and just seems cheaper quality. I added intercom to the rear seats and wired up new avionics with this (GMA 345, GTR 225, G5 HSI - with the exception of the CAN Bus wiring, for which I used purpose-made CAN Bus wiring I also bought from Spruce).