THE AVIATION SUPERSTORE FOR ALL YOUR AIRCRAFT & PILOT NEEDS | +61 (1800) 953522
Thumbs 1
Thumbs 1
Thumbs 1
Thumbs 1
Thumbs 1
+1 More

Dynon Skyview ADS-B With Custom Harness

$1018.60/Each
Price Includes GST
Part# 11-11939
MFR Model# ASA-00248-CU

Overview

Note: for use with the Dynon Skyview system only.

Dynon’s dual band ADS-B receiver receives weather & traffic on both 978 MHz and 1090 MHz frequencies.

The dual band SV-ADSB-472 receives ADS-B traffic via 978 MHz (UAT) and 1090 MHz. In the US, it also receives free text and graphical weather from the FAA’s network of ADS-B ground stations. Unlike portable ADS-B receivers, you get FULL ADS-B and radar traffic when you pair this with our Mode-S transponder. The remote mounted receiver utilizes an externally mounted antenna for superior ADS-B reception.

The ADS-B antenna must be installed at least two-feet from the transponder antenna.

ADS-B Weather: Subscription-free weather displayed on SkyView, including NEXRAD radar, METARs and TAFS. Airport weather data can be displayed for nearest airports or for a specific airport identifier.


TFR Information: TFR NOTAMs are displayed graphically on the navigation map.


ADS-B Traffic: Receives ADS-B traffic targets with precise location, altitude, speed, and direction. Includes both traffic broadcast from other aircraft equipped with ADS-B UAT transmitters and data broadcast from ADS-B ground stations. For full FAA 2020 ADS-B mandate compliance, pair this receiver with Dynon’s SV-XPNDR-261 and SV-GPS-2020 modules for the industry’s most affordable ADS-B Out.

Antenna Information: The SV-ADSB-472 requires its own antenna; it cannot share the transponder's antenna. A UAT-specific antenna or a transponder antenna may be used with the SV-ADSB-472.

Please note any ADS-B unit will operate within the USA only when in clear line of sight of an ADS-B tower (flying at a higher altitudes may be required to gain proper signal).
For more information please visit:FAA Link

To Obtain This Feature:
You Need:
ADSB-B Traffic
SkyView System:
10-03932 or 10-03933
SV-ADSB-472:
10-06419
SV-XPNDR-261/262:
10-04518 or 10-04519
ADS-B Weather and TFR's
(US only in current ADS-B coverage areas)
SkyView System:
10-03932 or 10-03933
SV-ADSB-472:
10-06419
TIS Traffic
(Non-ADS-B. Available today for U.S in some primary radar coverage areas. SV-ADSB-472 replaces TIS with ADS-B traffic)
SkyView System:
10-03932 or 10-03933
SV-XPNDR-261/262:
10-04518 or 10-04519

Specifications

  • Dimensions: The SV-ADSB-472 is approximately 2.79" x 4.10" x .97" in outside dimensions.
  • Weight: 0.3 lb. (0.12 kg)
  • Power: 0.05A @ 12V DC

Harness

  • Part No. 11-11938 (DYNON SKYVIEW ADS-B WITH 4FT HARNESS): Comes with 4 ft leads for power, ground, and data lines.
  • Part No. 11-11939 (DYNON SKYVIEW ADS-B WITH CUSTOM HARNESS): Required questions in the shopping cart regarding lengths of various connectors.

  • Note: Antenna connector is female BNC Out. Need a male BNC to connect to.

Reviews

Functioned well.

Michael S
April 1, 2021

A neat setup to make you ADSB work on your Dynon

Ronnie
February 15, 2021

I have not installed it yet but I have bought Dynon b3fore and have been pleased.

Paul S
January 30, 2021

These are made (I guess) by Dynon. I wish the wires ends were marked as to where they go. Ito me the average builder it’s hard to figure out where they hook up to. I’m sure others can figure it out but would be so simple if Dynon would just use wires that had where they go, like spruce does.

Ronnie
January 1, 2021

Works as stated. Necessary if you fly experimental within B class airports with 30 mile Mode C radius veil.

Randy V
May 24, 2020

New EMS module corrected RF EMI issue on Skyview Classic display.

John K
September 22, 2019

Teodor S
March 1, 2019

Needed a backup battery for a Skyview display and very few companies stock them. You do, which saved a lot of shipping time coast to coast. Thanks again for the great service.

Steve T
January 15, 2019

Wayne K
May 26, 2018

dynon skyview knob and pa panel

Gahide
May 12, 2014

Q&A

Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.

Q: What is the appropriate antenna cable for the transponder with a 6 ft run?

You have the option of RG 400 or RG 58 coax cable. RG 400 is a higher quality cable but either will work.

Q: Is the Skyview system from Dynon usable for certified aircraft?

No, the Skyview system is not TSO'd and is intended for experimental aircraft.

Q: Which antenna will work with the Dynon Skyview ADS-B unit?

Dynon recommend the AV-74 our part number 11-05846.

Q: Are the D-sub pins on the Dynon cables standard or high density pins?

They are standard density pins.

Q: Can you provide a diagram of the EMS fuel flow sensor ? Dimensions ?

This would be part number 10-01196. The diagram is under the documents tab.

Q: Can this Dynon Skyview system be installed on a King Air C90?

No, this system is not FAA Approved and is intended for use in experimental aircraft only.

Q: Although the Dynon SkyView system is not TSOd..can it be fitted as a back up system in a certificated aircraft--or are products such as Garmin the only option....

Unfortunately, this unit cannot be installed in a certificated aircraft even as a back up. Please see the certified G5 for a qualifying unit.

Q: Do you sell the Skyview 10 HDX?

Yes, you can find it on our website by keyword searching "Skyview HDX" or part # 10-06254.

Q: Does the Autopilot Panel, part #'s 10-05614 and 10-05613 come with the necessary parts to make the 15-pin connector?

Yes, these will include the connector kits.

Q: What type of servo is provided with the Sonex Roll with servo kit 10-05886? Is it a SV32L (long arm)?

The servo provided is the SV42EL.

View in Catalog

View Image View in Catalog