This flexible 15 ft LED Lighting strip is powered by 12volts, is adhesive backed and waterproof - allowing you to install it in any location you want light to glow. This LED Lighting strip can be powered directly with 12v as a light source for footwells, dome lighting, passenger areas, etc.
LED Lighting comes in Red, White, and Blue with a black flexible PC Board technology, and clear silicone-based flexible covering. |
These lights work very well. Have seen reviews where the tape doesn’t hold so i purchased some double-sided 3m tape to assist. Installation was easy! Didn’t know that i coukd use either end to make this work so I ended up with twice as much, since these were short runs on an rv. (Just note the lights start position is off so plan ahead)
LED Lighting Flexible Strip - White
👍👍👍👍
LED Lighting Flexible Strip - White
👍👍👍👍👍
LED Lighting Flexible Strip - White
I purchased the white light and it has a blue tint to it. You can dim it and looks nice, but not truly white light.
It’s pretty dim. I used a3 ft length of it in a dark baggage area and unless it’s pitch black outside you really can’t tell that the light is on. The Pilot Flex LED is several times brighter.
LED Lighting Flexible Strip - White
Received the kit and while planning the installation I found the knob is the wrong type for the pot. The pot has splines and the knob uses a flat, half round slot. Additionally, the instructions say there are cut lines, but none are visible. I would assume it’s between the four copper squares. More after the install.
The old adage you get what you pay for certainly holds true for this product. The lights are barely adequate, and I had to use two strips in parallel to accomplish that. The Supplied knob fits a half round shaft and the shaft in the kit is a splined shaft so it’s wrong knob. The adhesive barely stuck and I had to use a contact cement to get it to stick. If it holds a year I’ll be surprised.
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
The strip is 15 ft long.
This product does not have any FAA Approval.
They come with pin style connectors that would plug into a lighting controller. The strip itself has bare wire ends.
Yes, these strips can be cut to length.
Yes, this strip can be dimmed with a standard LED dimmer.
You would need to peel back and splice the wires but it would be done at your discretion.
Part # 11-06674 is the dimmer that is most commonly ordered with this strip.