Aircraft | Model | Barry PN | Engine | Part No. |
---|---|---|---|---|
Chaparral, 231 | M20E 1964 Only, M20A | 94150-01 | 0-360-A1A | 94150-01 |
Barry Controls has actively supported the general aviation market since 1981 and holds PMA approvals on a wide range of engine mounts. Barry mounts are warranted for 500 hours or 12 months and feature outstanding quality & value. Call for unlisted part numbers. Please refer to to the Application List in PDF format to confirm correct Barry Mount Part No. for your aircraft & engine make & model. |
Great product awesome instructions!
94150-01 Barry Mount
Mounts look great and I’m sure they will perform just fine , another quality product from aircraft spruce
94150-01 Barry Mount
My parts arrived quickly and they were exactly what I needed. Thanks
Outstanding service
Check the chart very carefully for the correct a/c model. Expensive but are better and cheaper than lord mounts.
worked perfectly on a Cessna 182P
Two out of the four mounts SPLIT on install! Terrible quality! Thank God we saw it split on install, and not discover it long after wed been flying. Quality control here was NOT in check on this run. Shame on the manufacturer for shipping this garbage.
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Qty 1 mount is a single mount assembly, two halfs and a spacer. Qty 4 assy's are required for a complete installation.
No. They will only include the bushing. All mounting hardware needs to be purchased separately.
This comes with 2 halves of a sandwich mount and a squared center piece.
Approx 2.66".
The diameter at the larger end is 2".
We recommend looking at the full application guide under the documents tab on our website. It really depends on the aircraft model and serial number as to which mounts or combination of mounts is correct for your aircraft.
The Baron 58 will use qty 4 of 96068-01.
This would be P/N# 94150-01.