A blend of solvents used for viscosity and drying control of Poly-Brush, Poly-Spray and Poly-Tone. Blend #R-65-75 is recommended as the standard reducer in normal weather, 65°75°F. #RR-8500 is a retarder-reducer with slower drying time. Recommended for temp above 85° & warm humid weather. Important Notice: All mixed paints are special order and are non-returnable. |
Poly-Fiber products for repairing some access panel holes that have worn out. This system is easy, fast and dependable. I have Poly-Fiber paint from 20 years ago that is still good. Cant go wrong with it.
Poly-Fiber R65-75 Reducer Quart
What can I say? Its a gallon of reducer.
Poly-Fiber R65-75 Reducer Gallon
Works like it should. I give you guys a lot of credit for you packing and shipping. Always packed very well and always get paint etc. in two days. Awesome
Poly-Fiber R65-75 Reducer Gallon
Poly-Fiber Rr 8500 Reducer Quart
packaged in a non waist full size. I didnt need much and this was just right.
Poly-Fiber R65-75 Reducer Quart
Haven’t used anything yet but fast shipping
Poly-Fiber R65-75 Reducer Quart
Poly-Fiber R65-75 Reducer Quart
Keep the cap screwed down tight or it will evaporate away. Keep them in a dry place, too, as one wee rust spot and it will evaporate through that too.
Poly-Fiber R65-75 Reducer Gallon
THE REDUCER WORKS GREAT WITH THE PAINT. THANK YOU
Poly-Fiber R65-75 Reducer Quart
Very good
Poly-Fiber R65-75 Reducer Gallon
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
You would use a 3:1 Mix Ratio. 3 Poly Tone, 1 R65-75 Reducer.