Custom Aircraft Grips PTT or Autopilot, SPST N/O, with Dust Cover. |
Reliable so far.
Cag PTT Spst Normally Off With Dust Cover
Very satisfied
Cag PTT Spst Normally Off With Dust Cover
Fits perfectly and works as advertised
Cag PTT Spst Normally Off With Dust Cover
Great quality little switch with a small footprint, especially for my pilot yolk on my Piper Cherokee since the trim switch takes up so much space.
Cag PTT Spst Normally Off With Dust Cover
Used it as a PTT swicht on my PA28 yoke. Discrete, good quality. Don
Cag PTT Spst Normally Off With Dust Cover
So far so good!
Everything as stated. Will install next month.
My ptt switch in my 1967 PA28-180 was showing signs of deterioration and needed replacement. This switch so far has been a suitable replacement although it does require a bit more thumb pressure for positive switching. The rubber dust cover increases the surface area which makes a more comfortable surface to press.
This should replace most PTT switches. Pricey but does not have a snap-on button like the cheaper switches. I found cheaper switch snap-on buttons would pop off as I brushed my leg over them. That’s why I spent the extra money to purchase this switch—the button is one piece. Time will tell how the contacts hold-up.
The threaded portion needs to be 2mm longer for most panel thicknesses.
Cag PTT Spst Normally Off With Dust Cover
Please note, Aircraft Spruce Australia's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Aircraft Spruce Australia assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
We have added the spec sheet with dimensions included to the 'Documents' tab on the web page.
It comes with a standard hex nut to mount the switch, but the dust cover has a knurled edge.
We do not have an application guide for this item by aircraft. We cannot say for sure what modifications would be necessary in your specific aircraft. We recommend discussing with your A&P installer to determine if this item will work.